List of top Questions asked in AP ECET Agricultural Engg

If the matrix \[ A=\begin{bmatrix} 1 & 2 & 3\\ 4 & 5 & 6\\ 7 & 8 & 9 \end{bmatrix}, \] then which of the following is true?
In Chezy's equation, ‘R' stands for
Darcy's equation is applicable for
The moment of a couple is given by
Lami's theorem is applicable to
The process of finding a single force that can replace multiple forces acting on a body is called
The instrument used for testing flatness of surface, marking parallel lines and also for marking and testing of right angles is
The machine used for producing cylindrical, conical (tapered) and spherical components is
Arc welding is carried out with a voltage of
The device used to hold round material of small diameter such as wire and pins is
The least count of micro meter is
Which of the following are used to irrigate a particular portion of the command area at a time directly from the flow through the pipe without the use of any field channel?
The sprinkler heads commonly used to irrigate small lawns and gardens are
Which of the following drippers are most suitable on slopes and difficult topographic terrains?
In drip system, the pressure ratings of lateral pipes are usually ____kg/cm2
The sprinkler system is not usually suitable for heavy clay soils where the infiltration rate is less than
The field level application efficiency of conventional surface irrigation method is
Plantation of high water consuming trees for withdrawal of groundwater is termed as
Exchangeable sodium percentage (ESP) of an alkali soil is
In mole drainage system, mole drains are commonly installed at depths between
The ratio of the volume of water discharged by the drain during a certain period to the precipitation generated in that period is known as
The safety measure provides against overtopping of channels due to wave action or other unforeseen reasons is
The permanent irrigation channels should not usually have side slopes steeper than
The water measuring device which does not get clogged due to suspended silt or floating debris during measurement is
The diameter of opening in Orifices ranges from