List of top Mechanical Engineering Questions on Strength of Materials asked in TS PGECET

In general, a sudden jump in the bending moment diagram is due to the following type of loading condition?
Based on the limiting factor to prevent bursting in thin cylinder, the design is primarily made based on which stress
A tapering bar varying from the diameters from `d\(_1\)' to `d\(_2\)' and a bar of uniform cross section `d' have the same length and subjected to same axial pull attains the same extension. Then the `d' is equal to
A circular shaft has been designed for the twisting moment of $5\text{ kN}\cdot\text{m}$. If the twisting moment is reduced to $4\text{ kN}\cdot\text{m}$, then what will be the maximum value of bending moment that can be applied for the same designed condition?
A long steel column of uniform cross section is subjected to a crippling load of $10\text{ kN}$ as per the Euler designed condition. If the length of the column is reduced to half, then what would be the maximum Euler's crippling load?
Two bars A and B made of different material have same length. The coefficient of expansion and Young's modulus of bar B is twice that of bar A. If the temperature of both bars is increased by the same amount while preventing any expansion, then the ratio of stress developed in bar A to that in bar B is
The relation of three elastic constants of a metal in terms of Young's Modulus (E), Modulus of rigidity (G) and Bulk Modulus (K) is expressed as
Which planes carry maximum normal stress and what is shear stress on these planes