Exams
Subjects
Classes
Home
CUET (PG)
Electrical Power And Ener...
List of top Electrical Power And Energy Engineering Questions on Project Management asked in CUET (PG)
Arrange the following :
• [A.] SCR anode is made positive with respect to cathode
• [B.] Junction \(J_1\) and \(J_3\) become forward biased
• [C.] Gate current injects minority carriers
• [D.] Regenerative feedback builds conduction
• [E.] Latching current sustains device ON state Choose the correct answer from the options given below :
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
Arrange the following statements :
• [A.] Abnormal impedance appears on transmission line
• [B.] Relay comparator detects deviation from set value
• [C.] Relay output contacts close
• [D.] Trip coil of circuit breaker is energised
• [E.] Breaker contacts interrupt fault current Choose the correct answer from the options given below :
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
Match List - I with List - II.
List - I
List - II
A. Load Flow Analysis
B. Stability Studies
C. Economic Load Dispatch
D. Synchronous Machine
I. V-curve
II. B-coefficient
III. Gauss-Seidel Method
IV. Equal-Area Criteria
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
Arrange the following statements :
• [A.] Pulverized fuel is injected into the furnace
• [B.] Chemical Energy converted into thermal Energy
• [C.] High temperature gases transfer heat to boiler tubes
• [D.] Water undergoes phase change into superheated steam
• [E.] Steam energy is delivered to turbine blades Choose the correct answer from the options given below :
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
Given below are two statements : one is labelled as Assertion (A) and the other is labelled as Reason (R). Assertion (A) : Thyristors can be turned off by gate control. Reason (R) : Thyristors require current to fall below holding current to turn off. In the light of the above statements, choose the most appropriate answer from the options given below :
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
Match List - I with List - II.
List - I
List - II
A. Thyrite arrester
B. Sag Template
C. Cable Sheaths
D. Circuit Breaker
I. Tower Location
II. Cross Bonding
III. Restriking voltage
IV. Non-linear resistor
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
Match List - I with List - II.
List - I
List - II
A. Three Phase Induction Motor
B. Three Phase Alternator
C. Transformer
D. Single phase Induction Motor
I. Constant Frequency
II. Not self starting
III. Always runs at less than synchronous speed
IV. Always runs at synchronous speed
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
In load flow studies, PV bus is treated as a PQ bus, when :
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
In a thermal power plant coal is used for the generation of electricity. How energy changes from one form to another before it is transformed into Electrical energy ?
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
Power factor can be improved by installing a device in parallel with load which has :
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
The per unit impedance of a circuit is 0.25. If the base kV and base MVA are halved, then the new value of p.u. impedance of the circuit will be :
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
A thyristor controlled reactor is used to get :
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
The Insulation Resistance of a 3 km long cable is \(200 \, \text{M}\Omega\). For length of \(15 \, \text{km}\), the Insulation Resistance will be :
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
Direct laying method of laying underground cables has the drawback of : A. High maintenance cost
B. Localisation of fault is difficult
C. Possibility of damage of cable sheath owing to undergoing chemical changes due to impurities present in soil
D. Risk of cable being damaged
E. Low maintenance cost Choose the correct answer from the options given below :
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
In load flow studies of a power system, a voltage control bus is specified by :
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
The maximum short circuit current occurs in case of :
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
Operation of an Op-Amp with Negative feedback : A. Error voltage becomes very small
B. Output stabilizes
C. Input signal applied
D. Feedback signal is generated Choose the correct answer from the options given below :
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
For frequency Response Analysis of an operational Amplifier : A. Identify dominant poles
B. Draw Bode magnitude plot
C. Apply gain-bandwidth product concept
D. Determine closed loop gain
E. Assess stability margin Choose the correct answer from the options given below :
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
Match List - I with List - II.
List - I
List - II
A. LED
B. Avalanche photo diode
C. Tunnel diode
D. LASER
I. Heavy doping
II. Coherent Radiation
III. Spontaneous Emission
IV. Current Gain
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
Match List - I with List - II.
List - I
List - II
A. Tunnel diode
B. PIN diode
C. Zener diode
D. Photodiode
I. Reading of film Sound Track
II. High frequency oscillator circuits
III. Very high frequency switching circuits
IV. Reference voltage
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
Match List - I with List - II (Semiconductor devices).
List - I
List - II (Characteristics)
A. BJT
B. MOS capacitor
C. Laser Diode
D. JFET
I. Population Inversion
II. Pinch-off Voltage
III. Early Effect
IV. Flat-band Voltage
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
Given below are two statements : one is labelled as Assertion (A) and the other is labelled as Reason (R). Assertion (A) : An ADC converts digital signal into Analog signals. Reason (R) : DAC performs the inverse operation of ADC. In the light of the above statements, choose the most appropriate answer from the options given below :
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
Given below are two statements : one is labelled as Assertion (A) and the other is labelled as Reason (R). Assertion (A) : A Zener diode is used for voltage regulation. Reason (R) : It maintains a nearly constant voltage in reverse breakdown region. In the light of the above statements, choose the most appropriate answer from the options given below :
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
Given below are two statements : one is labelled as Assertion (A) and the other is labelled as Reason (R). Assertion (A) : Superposition theorem is applicable only to linear circuits. Reason (R) : The response in non-linear circuits is not directly proportional to excitation. In the light of the above statements, choose the most appropriate answer from the options given below :
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
Arrange the following statements :
A. Stator winding is energized with balanced three phase supply
B. Spatially displaced currents create phase shifted fluxes
C. Resultant magnetic field rotates at synchronous speed
D. Rotor conductor cuts the rotating flux
E. Electromagnetic torque is produced Choose the correct answer from the options given below :
CUET (PG) - 2026
CUET (PG)
Electrical Power And Energy Engineering
Project Management
<
1
2
3
>