Exams
Subjects
Classes
Home
TS EAMCET
Physics
List of top Physics Questions on Semiconductor electronics: materials, devices and simple circuits asked in TS EAMCET
The substance which has an energy band gap equal to the energy of the spectral line corresponding to the shortest wavelength of Paschen series of the hydrogen spectrum is:
TS EAMCET - 2026
TS EAMCET
Physics
Semiconductor electronics: materials, devices and simple circuits
The resultant logic gate of the combination of logic gates given in the circuit is:
TS EAMCET - 2026
TS EAMCET
Physics
Semiconductor electronics: materials, devices and simple circuits
An electron in n-region enters p-region with speeds $5\times10^5$ m/s and $3\times10^5$ m/s before and after barrier. Find barrier potential.
TS EAMCET - 2026
TS EAMCET
Physics
Semiconductor electronics: materials, devices and simple circuits
Two OR gates and one AND gate are connected as shown. Find correct truth table output Y.
TS EAMCET - 2026
TS EAMCET
Physics
Semiconductor electronics: materials, devices and simple circuits
The ratio of energies of forbidden bands of silicon and germanium is nearly
TS EAMCET - 2026
TS EAMCET
Physics
Semiconductor electronics: materials, devices and simple circuits
A pure silicon with $6 \times 10^{28}$ atoms is doped with arsenic of 1 ppm concentration. If the intrinsic carrier concentration is $1.2 \times 10^{16} m^{-3}$, then the number of holes in the doped silicon is}
TS EAMCET - 2026
TS EAMCET
Physics
Semiconductor electronics: materials, devices and simple circuits
The negative feedback in an amplifier
TS EAMCET - 2025
TS EAMCET
Physics
Semiconductor electronics: materials, devices and simple circuits
The current amplification factor of a transistor in common emitter configuration is 80. If the emitter current is 2.43 mA, then the base current is
TS EAMCET - 2025
TS EAMCET
Physics
Semiconductor electronics: materials, devices and simple circuits
Which of the following logic gates is a universal gate?
TS EAMCET - 2025
TS EAMCET
Physics
Semiconductor electronics: materials, devices and simple circuits
The graph between the input voltage ($V_i$) and the output voltage ($V_o$) of a transistor connected in common emitter configuration is shown in the figure. The active, saturation and cutoff regions of the transistor are respectively
TS EAMCET - 2025
TS EAMCET
Physics
Semiconductor electronics: materials, devices and simple circuits
For a common emitter transistor amplifier, the voltage across the collector resistance is 2.8 V. If the current amplification factor of the transistor is 70 and the collector resistance is 2 k$\Omega$, then the base current is
TS EAMCET - 2025
TS EAMCET
Physics
Semiconductor electronics: materials, devices and simple circuits
If the breakdown voltage of a Zener diode is 7.2 V and the maximum power dissipated is 216 mW, then the maximum current through the Zener diode is
TS EAMCET - 2025
TS EAMCET
Physics
Semiconductor electronics: materials, devices and simple circuits
Five logic gates are connected as shown in the figure. If the inputs are A=C=1 and B=D=0, then the values of y1 and y2 respectively are
TS EAMCET - 2025
TS EAMCET
Physics
Semiconductor electronics: materials, devices and simple circuits
A Zener diode of breakdown voltage 6 V is connected as shown in the circuit. The power dissipated in the Zener diode is
TS EAMCET - 2025
TS EAMCET
Physics
Semiconductor electronics: materials, devices and simple circuits
The intrinsic carrier concentration of a semiconductor is $1.2\times10^{16}$ m$^{-3}$. On doping with an impurity, the electron concentration becomes $20\times10^5$ times initial concentration. The concentration of holes in the doped semiconductor is:
TS EAMCET - 2025
TS EAMCET
Physics
Semiconductor electronics: materials, devices and simple circuits
In a common emitter amplifier, the collector resistance is 3 times the base resistance. If the common emitter current amplification factor is 60, then the power gain of the amplifier is:
TS EAMCET - 2025
TS EAMCET
Physics
Semiconductor electronics: materials, devices and simple circuits
If the energy gap of a semiconductor used for the fabrication of an LED is nearly 1.9 eV, then the color of the light emitted by the LED is
TS EAMCET - 2025
TS EAMCET
Physics
Semiconductor electronics: materials, devices and simple circuits
According to a graph drawn between the input and output voltages of a transistor connected in common emitter configuration, the region in which transistor acts as a switch is
TS EAMCET - 2025
TS EAMCET
Physics
Semiconductor electronics: materials, devices and simple circuits