Question:medium

Flange wrinkling is the defect found in

Show Hint

Wrinkling = Compression. In deep drawing, the outer edge is squeezed together, causing it to fold if not held down properly.

Updated On: Jul 4, 2026

Rolling
Forging
Bending
Deep drawing

Show Solution

The Correct Option is D

Solution and Explanation

Was this answer helpful?

0

Top Questions on Metal forming processes

Tomlinson and Stringer defined the coefficient of spread S in cogging as the ratio of
- TS PGECET - 2026
- Metallurgical Engineering
- Metal forming processes
View Solution
Temper rolling improves all of the following except
- TS PGECET - 2026
- Metallurgical Engineering
- Metal forming processes
View Solution
The term merchant mill refers to a rolling mill designed to roll
- TS PGECET - 2026
- Metallurgical Engineering
- Metal forming processes
View Solution
Impact extrusion is a process used to produce
- TS PGECET - 2026
- Metallurgical Engineering
- Metal forming processes
View Solution
Want to practice more? Try solving extra ecology questions todayView All Questions

Questions Asked in AP ECET Metallurgical Eng exam

Order of the matrix $\begin{bmatrix} 1 & 6 \\ 2 & 0 \\ 7 & -1 \end{bmatrix}$ is

If two rows (or columns) of a determinant of order 3 are identical then the value of determinant is

Co-factor of -4 in $\begin{vmatrix} 1 & 2 & 3 \\ -4 & 3 & 6 \\ 2 & -7 & 9 \end{vmatrix}$ is

The Matrix $\begin{bmatrix} a & h & g \\ h & b & f \\ g & f & c \end{bmatrix}$ is