Question:medium

Draft on pattern for casting is

Show Hint

Draft = Taper. Think of a plastic cup; the slanted sides make it easy to pull out of a stack.

Updated On: Jul 4, 2026

For machining allowance
For shrinkage allowance
Tapered to facilitate its easy removal from mould
For Machining allowance

Show Solution

The Correct Option is C

Solution and Explanation

Was this answer helpful?

0

Top Questions on Casting and Foundry

The impurities in centrifugal casting are
- AP ECET Metallurgical Eng - 2025
- Metallurgical Engineering
- Casting and Foundry
View Solution
Wood flour is added to the moulding sand to improve
- AP ECET Metallurgical Eng - 2025
- Metallurgical Engineering
- Casting and Foundry
View Solution
An expandable pattern is used in
- AP ECET Metallurgical Eng - 2025
- Metallurgical Engineering
- Casting and Foundry
View Solution
The riser is designed such that the melt in the riser solidifies
- AP ECET Metallurgical Eng - 2025
- Metallurgical Engineering
- Casting and Foundry
View Solution
Want to practice more? Try solving extra ecology questions todayView All Questions

Questions Asked in AP ECET Metallurgical Eng exam

Order of the matrix $\begin{bmatrix} 1 & 6 \\ 2 & 0 \\ 7 & -1 \end{bmatrix}$ is

If two rows (or columns) of a determinant of order 3 are identical then the value of determinant is

Co-factor of -4 in $\begin{vmatrix} 1 & 2 & 3 \\ -4 & 3 & 6 \\ 2 & -7 & 9 \end{vmatrix}$ is

The Matrix $\begin{bmatrix} a & h & g \\ h & b & f \\ g & f & c \end{bmatrix}$ is