List of top Fluid Mechanics and Thermal Sciences Questions on Heat Transfer asked in GATE ME

Two rectangular surfaces both having 1 m² area are placed perpendicular to each other with a common edge. One surface is hot, having a temperature of 1000 K and emissivity of 0.4, while the other is insulated and in radiant balance with a large surrounding room at 300 K. If the fraction of radiation leaving the hot surface which reaches the cold surface is 0.2, then the equivalent overall resistance for the radiation heat loss from the hot surface is _______ m^-2 (rounded off to 2 decimal places).

Convective heat transfer coefficients for Fluid 1 and Fluid 2 in a heat exchanger, as shown in the figure below, are 50 W/(m²K) and 80 W/(m²K), respectively. The inner tube is made of a material which has a thermal conductivity 386 W/(m K) for the given range of temperatures in the heat exchanger. The length of the heat exchanging surface, the inside radius of the inner tube, and thickness of the inner tube are 1 m, 10 mm, and 1 mm, respectively. Considering no heat exchange between the outer tube and the surrounding, the heat transfer rate for the heat exchanger is ________ W (rounded off to 1 decimal place).

A very long fin of a uniform square cross-section is replaced by another very long fin of a uniform circular cross-section of the same material. Assume uniform and identical heat transfer coefficient for both the fins. If the diameter of the circular fin is equal to the side length of the square fin, then the ratio of heat transfer rates before and after the replacement is

A quiescent fluid at temperature T3 is confined between two vertical parallel plates. While plate 1 is kept at temperature T1 and plate 2 is maintained at temperature T2, a velocity profile between the plates, as shown in the figure below, is generated due to heat transfer.

Which one of the following options shows the correct relations among T1, T2, and T3?