Exams
Subjects
Classes
Home
Electronics Engineering
List of top Electronics Engineering Questions on communication systems
In binary data transmission, DPSK is preferred over PSK because
CUET (PG) - 2025
CUET (PG)
Electronics Engineering
communication systems
Coherent demodulation of FSK signal can be detected using
CUET (PG) - 2025
CUET (PG)
Electronics Engineering
communication systems
Consider the signal x(t) shown in the figure. Let h(t) denote the impulse response of the filter matched to x(t), with h(t) being non-zero only in the interval 0 to 4 sec. The slope of h(t) in the interval 3 greater than t greater than 4 sec is
CUET (PG) - 2025
CUET (PG)
Electronics Engineering
communication systems
A baseband PCM system with a matched filter at the receiver is implemented with \(\pm 5\) V bipolar with a pulse duration of 72\(\mu\) sec. If the noise PSD is \(1.0 \times 10^{-4} V^2/Hz\), the probability of error in this system is given by
CUET (PG) - 2025
CUET (PG)
Electronics Engineering
communication systems
Match List-I (modulation/generation techniques) with List-II (disadvantages/generated signal) and select the correct answer from the given codes:
CUET (PG) - 2025
CUET (PG)
Electronics Engineering
communication systems
A 10 kW carrier is sinusoidally modulated by two carriers corresponding to a modulation index of 30% and 40%, respectively. The total radiated power is
CUET (PG) - 2025
CUET (PG)
Electronics Engineering
communication systems
The subsystems in an FM receiver are
A. Mixer
B. RF amplifier
C. Limiter
D. IF amplifier
Choose the correct sequence of subsystems in an FM receiver from the options given below:
CUET (PG) - 2025
CUET (PG)
Electronics Engineering
communication systems
The image channel rejection in a superheterodyne receiver comes from
CUET (PG) - 2025
CUET (PG)
Electronics Engineering
communication systems
Theorem/law and its corresponding specified quality are given in the table below. Match List-I with List-II
CUET (PG) - 2025
CUET (PG)
Electronics Engineering
communication systems