The Block diagram for a control system is shown below:
The Block diagram for a control system is shown below:
Show Hint
- 0.2
- 0.3
- 0.4
- 0.5
The Correct Option is C
Solution and Explanation
Step 1: Apply the steady-state error formula.
For a unit step input, the steady-state error is determined by the final value theorem or by evaluating the system's response at its steady state.
Step 2: State the conclusion.
The steady-state error for the system is calculated to be 0.4, thus option (C) is the correct selection.
Top Questions on Control Systems
Given an open-loop transfer function \(GH = \frac{100}{s}(s+100)\) for a unity feedback system with a unit step input \(r(t)=u(t)\), determine the rise time \(t_r\).
- GATE EE - 2026
- Control Systems
- Control Systems
- In the series circuit shown containing a voltage source (V), a diode (D), a resistor (R), an inductor (L), and a capacitor (C), which of the following components are considered linear?
- GATE EE - 2026
- Control Systems
- Control Systems
Consider a linear time-invariant system represented by the state-space equation: \[ \dot{x} = \begin{bmatrix} a & b -a & 0 \end{bmatrix} x + \begin{bmatrix} 1 0 \end{bmatrix} u \] The closed-loop poles of the system are located at \(-2 \pm j3\). The value of the parameter \(b\) is:
- GATE EE - 2026
- Control Systems
- Control Systems
- Which of the following statements is correct about the small-signal voltage gain of single-stage MOSFET amplifiers? Consider the statement: "Both common source and common gate amplifiers are inverting amplifiers."
- GATE EE - 2026
- Control Systems
- Control Systems
- Want to practice more? Try solving extra ecology questions todayView All Questions