Question:medium
In Dynamic hardness testing, the hardness is measured by
In Dynamic hardness testing, the hardness is measured by
Show Hint
Dynamic hardness tests are energy-based, not indentation-size based.
Updated On: Jun 29, 2026
- Size of the permanent indentation produced under a static load
- Resistance to plastic deformation
- Energy of impact
- Diagonal length of the indentation by a pyramidal indenter
Show Solution
The Correct Option is C
Solution and Explanation
Was this answer helpful?
0
Top Questions on Mechanical Metallurgy
- Match the following:
- TS PGECET - 2026
- Metallurgical Engineering
- Mechanical Metallurgy
- The stress at which the stress-strain curve deviates from linearity is:
- TS PGECET - 2026
- Metallurgical Engineering
- Mechanical Metallurgy
- The basis on which the Von Mises criterion is preferred compared to maximum shear stress criterion theoretically is:
- TS PGECET - 2026
- Metallurgical Engineering
- Mechanical Metallurgy
- Consider the following Assertion (A): The shape and magnitude of the stress-strain curve of a metal depend on its composition, heat treatment, prior plastic deformation, strain rate, temperature and state of stress during testing. Reason (R): Tensile strength and yield strength are strength parameters, whereas percent elongation and reduction of area are measures of ductility.
- TS PGECET - 2026
- Metallurgical Engineering
- Mechanical Metallurgy
- Want to practice more? Try solving extra ecology questions todayView All Questions