List of top Civil Engineering Questions on Reinforced Concrete Beams asked in AP PGECET

The average permissible stress in bond for plain bars in tension is
As per IS 456:2000, the maximum spacing of vertical stirrups is to be limited to
To avoid the limit state of collapse, the safety of RC structures is checked for appropriate combinations of dead load (DL), live load (LL), wind load (WL) and earthquake load (EQ). Which of the following combinations is not considered?
The maximum spacing of longitudinal bars measured along the periphery of a column is
The diameter of the lateral ties in a column shall in no case be less than
What is the minimum grade of concrete recommended in coastal areas according to IS 456:2000?
Which section is good from ductility point of view?
The average permissible stress in bond for plain bars in tension is
The diameter of the lateral ties in a column shall in no case be less than
What is the minimum grade of concrete recommended in coastal areas according to IS 456:2000?
Which section is good from ductility point of view?
As per IS 456:2000, the maximum spacing of vertical stirrups is to be limited to
To avoid the limit state of collapse, the safety of RC structures is checked for appropriate combinations of dead load (DL), live load (LL), wind load (WL) and earthquake load (EQ). Which of the following combinations is not considered?
The maximum spacing of longitudinal bars measured along the periphery of a column is
Normally, the tensile strength of concrete is about ______ of its compressive strength.
The section in which concrete is not fully stressed to its maximum permissible value while stress in steel reaches its maximum value is called ____
Maximum longitudinal reinforcement in columns shall not exceed ____
The analysis of slab spanning in one direction is done by assuming it to be a beam of
Lateral ties in reinforced concrete columns are provided to resist ____
A reinforced slab built monolithically with the supporting columns and is reinforced in two or more directions, without any provision of beams, is called a____
The neutral axis of the reinforced beam passes through ____